Browsing by Author "Zhu, Wenguo"

Now showing 1 - 4 of 4
  • Thumbnail Image
    Item
    Accurate measurement of nanomechanical motion in a fiber-taper nano-optomechanical system
    (AIP Publishing LLC, 2019) Zheng, Huadan; Qiu, Weiqia; Gu, Xiaohang; Zhang, Yu; Zhu, Wenguo; Huang, Bincheng; Lu, Huihui; Guan, Heyuan; Xiao, Yi; Zhong, Yongchun; Fang, Junbin; Luo, Yunhan; Zhang, Jun; Yu, Jianhui; Tittel, Frank; Chen, Zhe
    The hybrid systems that couple optical and mechanical degrees of freedom in nanoscale devices offer an unprecedented opportunity and development in laboratories worldwide. A nano-optomechanical (NOM) system that converts energy directly/inversely between optics and mechanics opens an approach to control the behavior of light and light-driven mechanics. An accurate measurement of the mechanical motion of a fiber-taper NOM system is a critical challenge. In this work, an optical microscope was used to measure the nanoscale mechanical motion of the fiber taper by introducing white light interference. The resolution of mechanical motion monitoring achieved 0.356 nm with an optomechanical efficiency of >20 nm/μW. This paper describes an approach to characterize NOM transducers between optical and mechanical signals in both classical and quantum fields.
  • Thumbnail Image
    Item
    Application of Micro Quartz Tuning Fork in Trace Gas Sensing by Use of Quartz-Enhanced Photoacoustic Spectroscopy
    (MDPI, 2019) Lin, Haoyang; Huang, Zhao; Kan, Ruifeng; Zheng, Huadan; Liu, Yihua; Liu, Bin; Dong, Linpeng; Zhu, Wenguo; Tang, Jieyuan; Yu, Jianhui; Chen, Zhe; Tittel, Frank K.
    A novel quartz-enhanced photoacoustic spectroscopy (QEPAS) sensor based on a micro quartz tuning fork (QTF) is reported. As a photoacoustic transducer, a novel micro QTF was 3.7 times smaller than the usually used standard QTF, resulting in a gas sampling volume of ~0.1 mm3. As a proof of concept, water vapor in the air was detected by using 1.39 μm distributed feedback (DFB) laser. A detailed analysis of the performance of a QEPAS sensor based on the micro QTF was performed by detecting atmosphere H2O. The laser focus position and the laser modulation depth were optimized to improve the QEPAS excitation efficiency. A pair of acoustic micro resonators (AmRs) was assembled with the micro QTF in an on-beam configuration to enhance the photoacoustic signal. The AmRs geometry was optimized to amplify the acoustic resonance. With a 1 s integration time, a normalized noise equivalent absorption coefficient (NNEA) of 1.97 × 10−8 W·cm−1·Hz−1/2 was achieved when detecting H2O at less than 1 atm.
  • Thumbnail Image
    Item
    Influence of Tuning Fork Resonance Properties on Quartz-Enhanced Photoacoustic Spectroscopy Performance
    (MDPI, 2019) Zheng, Huadan; Lin, Haoyang; Dong, Lei; Liu, Yihua; Patimisco, Pietro; Zweck, John; Mozumder, Ali; Sampaolo, Angelo; Spagnolo, Vincenzo; Huang, Bincheng; Tang, Jieyuan; Dong, Linpeng; Zhu, Wenguo; Yu, Jianhui; Chen, Zhe; Tittel, Frank K.
    A detailed investigation of the influence of quartz tuning forks (QTFs) resonance properties on the performance of quartz-enhanced photoacoustic spectroscopy (QEPAS) exploiting QTFs as acousto-electric transducers is reported. The performance of two commercial QTFs with the same resonance frequency (32.7 KHz) but different geometries and two custom QTFs with lower resonance frequencies (2.9 KHz and 7.2 KHz) were compared and discussed. The results demonstrated that the fundamental resonance frequency as well as the quality factor and the electrical resistance were strongly inter-dependent on the QTF prongs geometry. Even if the resonance frequency was reduced, the quality factor must be kept as high as possible and the electrical resistance as low as possible in order to guarantee high QEPAS performance.
  • Thumbnail Image
    Item
    Quartz-enhanced photoacoustic spectroscopy exploiting a fast and wideband electro-mechanical light modulator
    (Optical Society of America, 2020) Zheng, Huadan; Zheng, Huadan; Liu, Yihua; Lin, Haoyang; Kan, Ruifeng; Kan, Ruifeng; Dong, Lei; Dong, Lei; Zhu, Wenguo; Fang, Junbin; Yu, Jianhui; Yu, Jianhui; Tittel, Frank K.; Chen, Zhe
    A quartz-enhanced photoacoustic spectroscopy (QEPAS) gas sensor exploiting a fast and wideband electro-mechanical light modulator was developed. The modulator was designed based on the electro-mechanical effect of a commercial quartz tuning fork (QTF). The laser beam was directed on the edge surface of the QTF prongs. The configuration of the laser beam and the QTF was optimized in detail in order to achieve a modulation efficiency of ∼100%. The L-band single wavelength laser diode and a C-band tunable continuous wave laser were used to verify the performance of the developed QTF modulator, respectively, realizing a QEPAS sensor based on amplitude modulation (AM). As proof of concept, the AM-based QEPAS sensor demonstrated a detection limit of 45 ppm for H2O and 50 ppm for CO2 with a 1 s integration time respectively.