Browsing by Author "Qiao, Shunda"
Now showing 1 - 4 of 4
Results Per Page
Sort Options
Item A Sensitive Carbon Dioxide Sensor Based on Photoacoustic Spectroscopy with a Fixed Wavelength Quantum Cascade Laser(MDPI, 2019) Qiao, Shunda; Qu, Yanchen; Ma, Yufei; He, Ying; Wang, Yao; Hu, Yinqiu; Yu, Xin; Zhang, Zhonghua; Tittel, Frank K.A photoacoustic spectroscopy (PAS) based carbon dioxide (CO2) sensor with a fixed wavelength quantum cascade laser (FW-QCL) was demonstrated. The emission wavelength of the FW-QCL at 4.42 μm in the mid-infrared spectral region matched a fundamental CO2 absorption line. Amplitude modulation of the laser intensity was used to match the resonant photoacoustic (PA) cell. The noise from the background was reduced with the correlation demodulation technique. The experimental results showed that the sensor had excellent signal stability and a concentration linear response. When the integration time was 1 s, a 1σ minimum detection limit (MDL) of 2.84 parts per million (ppm) for CO2 detection was achieved. The long-term stability of the sensor was evaluated by means of an Allan deviation analysis. With an integration time of ~100 s, the MDL was improved to 1 ppm. This sensor was also used to measure the CO2 concentration from some common emission sources, such as cigarette smoking, automobile exhaust, and the combustion of some carbon-containing materials, which confirmed the stability and robustness of the reported FW-QCL based CO2-PAS sensor system.Item A Sensitive Carbon Monoxide Sensor Based on Photoacoustic Spectroscopy with a 2.3 μm Mid-Infrared High-Power Laser and Enhanced Gas Absorption(MDPI, 2019) Qiao, Shunda; Ma, Yufei; He, Ying; Yu, Xin; Zhang, Zhonghua; Tittel, Frank K.A photoacoustic spectroscopy (PAS)-based carbon monoxide (CO) gas sensor with a high-power laser and an enhanced gas absorption was demonstrated. The light source was a distributed feedback (DFB), continuous wave (CW) diode laser with a high output power of ~8 mW to give a strong excitation. The target gas received optical absorption enhanced two times by using a right-angle prism reflecting the laser beam. In order to reduce the noise from the background, wavelength modulation spectroscopy (WMS) and second-harmonic detection techniques were used. The modulation frequency and modulation depth were optimized theoretically and experimentally. Water vapor was added in the PAS sensor system to increase the vibrational–translational (V–T) relaxation rate of the CO molecule, which resulted in an ~8 times signal enhancement compared with the using of a dry CO/N2 gas mixture. The amplitude of the 2f signal had a 1.52-fold improvement compared to the one with only one time absorption. The experimental results showed that such a sensor had an excellent linear response to the optical power and gas concentration. At 1 s integration time, a minimum detection limit (MDL) for CO detection of 9.8 ppm was achieved. The long-term stability of the sensor system was evaluated with an Allan deviation analysis. When the integration time was 1100 s, the MDL improved to be 530 ppb. The detection performance of such a PAS-based CO sensor can be further improved when a laser with a higher output power and increasing optical absorption times is used.Item Highly sensitive acetylene detection based on multi-pass retro-reflection-cavity-enhanced photoacoustic spectroscopy and a fiber amplified diode laser(Optical Society of America, 2019) Ma, Yufei; Qiao, Shunda; He, Ying; Li, Yu; Zhang, Zhonghua; Yu, Xin; Tittel, Frank K.In this paper, a multi-pass retro-reflection-cavity-enhanced photoacoustic spectroscopy (PAS) based gas sensor is reported for the first time. The multi-pass retro-reflection-cavity consisted of two right-angle prisms and was designed to reflect the laser beam to pass through the photoacoustic (PA) cell four times, which improved the acetylene (C2H2)-PAS sensor signal level significantly. The optical power of a near-infrared distributed feedback (DFB) diode laser emitting a continuous wave (CW) was amplified to 1000 mW with an erbium-doped fiber amplifier. The background noise was reduced with wavelength modulation spectroscopy (WMS) and 2nd harmonic demodulation techniques. The linear optical power and concentration response of such a PAS sensor were investigated, and the experimental results showed excellent characteristics. When the integration the time of the sensor system was set to 1 s, the minimum detection limit (MDL) for C2H2 detection was 8.17 ppb, which corresponds to a normalized noise equivalent absorption coefficient (NNEA) of 1.84 × 10−8 cm−1W/√Hz. The long-term stability of such a multi-pass retro-reflection-cavity-enhanced PAS based C2H2 sensor was evaluated by an Allan deviation analysis. It was demonstrated that the multi-pass retro-reflection-cavity-enhanced PAS sensor had an excellent stability. An MDL of 600 ppt was achieved when the integration time was set to ~1000 s. It was verified that the method of multi-pass retro-reflection-cavity-enhanced PAS with an amplified laser source improved the sensor performance significantly. If an appropriate cavity design with increasing reflection times is used, the MDL of such a PAS-based sensor can be further improved.Item Trace gas sensing based on multi-quartz-enhanced photothermal spectroscopy(Elsevier, 2020) Ma, Yufei; Hu, Yinqiu; Qiao, Shunda; He, Ying; Tittel, Frank K.A multi-quartz-enhanced photothermal spectroscopy (M-QEPTS) based trace gas detection method is reported for the first time. Different from traditional QEPTS sensor employing a single quartz tuning fork (QTF) as a photothermal detector, two QTFs were used in M-QEPTS to increase the signal amplitude by adding the generated piezoelectric signals. The coating film of the QTFs was removed in order to improve the laser absorption and transmission. Acetylene (C2H2) was chosen as the target analyte. Wavelength modulation spectroscopy (WMS) and 2nd harmonic detection were utilized for the concentration detection. Limit of detection (LoD) of 0.97 ppm was achieved with a 1 second integration time for the M-QEPTS sensor, which realized a 1.51 times signal enhancement compared to a traditional QEPTS sensor employing a single QTF. By using an Allan deviation analysis approach, LoD of 0.19 ppm for an optimum integration time of 200 s was obtained.