Browsing by Author "Pi, Mingquan"
Now showing 1 - 3 of 3
Results Per Page
Sort Options
Item Mid-infrared chalcogenide slot waveguide plasmonic resonator sensor embedded with Au nanorods for surface-enhanced infrared absorption spectroscopy(Elsevier, 2022) Pi, Mingquan; Zhao, Huan; Li, Chunguang; Min, Yuting; Peng, Zihang; Ji, Jialin; Huang, Yijun; Song, Fang; Liang, Lei; Zhang, Yu; Wang, Yiding; Tittel, Frank K.; Zheng, ChuantaoThe problem of a traditional waveguide plasmonic resonator sensor is that part of the near-field intensity enhanced area is confined in the waveguide dielectric layer, which decreases the interaction effect between light and analyte. In order to solve this problem, a novel mid-infrared (MIR) chalcogenide (ChG) slot waveguide plasmonic resonator (SWGPR) sensor embedded with Au nanorods was proposed, where Au nanorods were used as antenna for enhancing mode coupling with the waveguide through resonance at the absorption wavelength of the analyte. The antenna parameters were optimized to make the resonance wavelength align with the absorption wavelength of the analyte. The proposed waveguide structure provides a sufficient sensing area and increases the electric field enhancement factor to > 6400. Polymethyl methacrylate (PMMA) and styrene were adopted as the analyte for sensing performance evaluation. The normalized absorption reaches 23.31 when the maximum extinction coefficient of PMMA is 0.08, which is at least 7 times higher than other silicon-on-insulator (SOI) waveguide plasmonic resonator sensors. The proposed waveguide structure provides a new idea for the design of other waveguide plasmonic resonator sensors with high sensing performance and has the potential for biochemical sensing.Item On-chip mid-infrared silicon-on-insulator waveguide methane sensor using two measurement schemes at 3.291 μm(Frontiers Media S.A., 2022) Zhao, Huan; Zheng, Chuantao; Pi, Mingquan; Liang, Lei; Song, Fang; Zhang, Yu; Wang, Yiding; Tittel, Frank K.Portable or even on-chip detection of methane (CH4) is significant for environmental protection and production safety. However, optical sensing systems are usually based on discrete optical elements, which makes them unsuitable for the occasions with high portability requirement. In this work, we report on-chip silicon-on-insulator (SOI) waveguide CH4 sensors at 3.291 μm based on two measurement schemes including direct absorption spectroscopy (DAS) and wavelength modulation spectroscopy (WMS). In order to suppress noise, Kalman filter was adopted in signal processing. By optimizing the waveguide cross-section structure, an etch depth of 220 nm was selected with an experimentally high power confinement factor (PCF) of 23% and a low loss of only 0.71 dB/cm. A limit of detection (LoD) of 155 parts-per-million (ppm) by DAS and 78 ppm by WMS at an averaging time of 0.2 s were obtained for a 2 cm-long waveguide sensor. Compared to the chalcogenide (ChG) waveguide CH4 sensors at the same wavelength, the reported sensor reveals the minimum waveguide loss and the lowest LoD. Therefore the SOI waveguide sensor has the potential of on-chip gas sensing in the mid-infrared (MIR) waveband.Item Slow-light-enhanced on-chip 1D and 2D photonic crystal waveguide gas sensing in near-IR with an ultrahigh interaction factor(Optica Publishing Group, 2023) Peng, Zihang; Huang, Yijun; Zheng, Kaiyuan; Zheng, Chuantao; Pi, Mingquan; Zhao, Huan; Ji, Jialin; Min, Yuting; Liang, Lei; Song, Fang; Zhang, Yu; Wang, Yiding; Tittel, Frank K.Nanophotonic waveguides hold great promise to achieve chip-scale gas sensors. However, their performance is limited by a short light path and small light–analyte overlap. To address this challenge, silicon-based, slow-light-enhanced gas-sensing techniques offer a promising approach. In this study, we experimentally investigated the slow light characteristics and gas-sensing performance of 1D and 2D photonic crystal waveguides (PCWs) in the near-IR (NIR) region. The proposed 2D PCW exhibited a high group index of up to 114, albeit with a high propagation loss. The limit of detection (LoD) for acetylene (C2H2) was 277 parts per million (ppm) for a 1 mm waveguide length and an averaging time of 0.4 s. The 1D PCW shows greater application potential compared to the 2D PCW waveguide, with an interaction factor reaching up to 288%, a comparably low propagation loss of 10 dB/cm, and an LoD of 706 ppm at 0.4 s. The measured group indices of the 2D and 1D waveguides are 104 and 16, respectively, which agree well with the simulation results.